Factory resetting the EIDC+

Perform the following to factory reset the EIDC+ Controller:

1. Power down the controller: Disconnect the power from the EIDC+ Controller.
2. Connect ports: Once powered down, connect a wire from the IN2 port to the BUZ port.
3. Restore power: After connecting the ports, restore power to the controller.
4. Wait for the IP address to display: Allow the controller to power up. After 15 seconds, the controller will display its IP address.
5. Remove the wire: As soon as the IP address starts to display, remove the wire from the ports.
6. Finish startup: Let the controller finish the startup sequence. Once complete, the EIDC+ has been factory reset.

Subscribe to our YouTube channel

Now that you’ve successfully restored your EIDC+ Controller to factory defaults, you’re ready to recommission the controller and continue optimizing your INFINIAS access control system.

For more INFINIAS tutorials, installation guides, and troubleshooting tips, be sure to subscribe to the 3xLOGIC YouTube channel so you never miss an update.